[. . . ] You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. W10532204A INSTALLATION INSTRUCTIONS Tools and Parts Tools Needed Gather the required tools and parts before starting installation. [. . . ] 2 cm) with non-flush receptacle Within recommended region Location Requirements The microwave oven may be installed over a built-in oven. If installing over a built-in oven, make sure there is a minimum of 3" (7. 6 cm) between the top of the lower oven cutout and the microwave oven cutout floor. The microwave oven may also be installed in a cabinet by itself (without a built-in oven below). Make sure the surrounding cabinetry has clearance to open and close freely. Allow a clearance of at least 1⁹⁄₁₆" (4. 6 cm] for installation above a built-in oven), and a clearance of at least 2" (5. 2 cm) with non-flush receptacle NOTES: ■ Depth requirements depend upon receptacle and its location within or outside of recommended region. Align the center arrows on the bottom duct with the centerline drawn in Step 1 above. Using 7/64" drill, drill pilot holes into the three holes marked in Step 4. Using 7/64" drill, drill pilot holes through the four mounting holes of the bottom duct flange into the bottom front facing of the cutout/cabinet opening. Center arrows, aligned with centerline 4 Install the Microwave Oven 1. Secure the microwave oven to the cutout/cabinet by installing four short screws into the mounting holes. wARNING A Electrical Shock Hazard Plug into a grounded 3 prong outlet. Failure to follow these instructions can result in death, fire, or electrical shock. The mounting holes of the rail flanges and bottom duct flange will align against the bottom front facing of the cutout/cabinet opening. [. . . ] Failure to follow these instructions can result in death, fire, or electrical shock. The mounting holes of the rail flanges and bottom duct flange will align against the bottom front facing of the cutout/cabinet opening. Position trim kit frame over the opening so that the lower tabs rest on the cutout floor, as shown. [. . . ]